How Do You Lay Rolled Roofing

Don t put nails any closer to the edge of the roof than 1 inch.

How do you lay rolled roofing. To seal a plumbing vent spread roofing cement around the pipe. Attach the strip to the roof every 3 inches with nails pulling it tight as you go. Add a second piece of full width roll roofing over the first. Then apply roofing cement evenly around the roof edges where these strips are going to go.

You need to place starter strips of roll roofing along all edges of the roof so start by cutting pieces of roofing about 18 inches wide. Step 1preparing to install rolled roofing prepare the roofing cut the roll roofing into lengths long enough to cover one run across the shed roof or of 18 whichever fits your shed better and lay them out on a flat surface to smooth them out. Nail the roofing in place with short roofing nails spaced 6 inches apart and 1 inch in from the outer edges of the roll roofing. This reduces the chances of wrinkles after the roofing is installed.

Nail it in place with roofing nails that penetrate at least 3 4 inch into. Do not use the eaves as a guide instead because they can be uneven. Prepare a valley between joined roofs by cutting a strip that is 18 inches wide and covers the entire length of the valley. Cut a hole in the roll roofing and slip it over as well.

Step 3 apply the edge strips. Overlap the next strip of roofing material with the first by at least 4 inches. Be careful not to get any on your skin in this process. Lay the first strip of material so that it overhangs the drip edges of your roof by about a quarter inch.

Cut a hole in a piece of roofing about 2 feet wide and slip it over the pipe.