How Do I Remove A Piece Of Vinyl Siding

To remove a piece at your eye level slide the zip tool under the piece above that one.

How do i remove a piece of vinyl siding. The vinyl siding zip tool will save you loads of time. You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down. How to remove and replace a section of vinyl siding. Insert the siding removal tool where the panels overlap and pull down and out.

With the other use the claw end of a hammer to pry up the nails holding the damaged piece of vinyl to the wall. Locate the vinyl siding piece above the piece you need to replace. Look under the siding piece you just located for a short flat notch. Start by lifting an overlapped piece of vinyl on the top row.

Look for a horizontal seam between two courses of vinyl siding. Installing a replacement piece of vinyl siding is the reverse of removing the damaged panel. Go to the end of that row either near a corner piece or a j channel. Repeat until you re at the ground and then remove the surrounding trim.

Once the zip tool is latched onto the lip pull the siding piece downward and slide the tool horizontally across the entire length of the panel unhooking the lip. Working in one direction unzip. Insert the tip of the zip tool into the. Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.

Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it. Zip tools disconnect a higher piece from a lower piece. Use a zip tool to disconnect two pieces of siding. Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.

Remove the nails one at a time to disconnect the entire length of vinyl. How to remove small pieces of vinyl siding. Hold the loose undamaged piece of vinyl up and out of the way with one hand.