How Do I Make A Roof Rake

On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through.

How do i make a roof rake. Position a bracket on each side of the. Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes. Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your. When the snow started to pile up on handyman bill.

Make sure the holes on the brackets are lined up and are angled at 90 degrees. I used the driveway sealer squeegee and an extension pole to work as a snow roof rake. I have to say it worked great i used the metal part face down not the rubber part. An added bonus was that i could use one end of.

Here s what i came up with. Use larger rake plates such as 1 by 4 inches and 1 by 6 inches when there is an infinity ledge at the end of the gable. Apply some pvc glue to the inside of the arms. Use the drill to make a hole in the aluminum pole using the bracket holes as a guide.

Make this easy avalanche roof rake for the winter and let a clever diy design do all the work for you. How to make a roof rake step 1. Measure and place a mark 2 from an end. The roof rake plates are installed in different widths depending on the surface being covered.

Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side. Attach the two 4 inch angle brackets to the end of your aluminum pole.